To replace the radio I used the PAC Audio RP4-VW11 to get the steering wheel controls working and getting power to work properly from the CAN BUS. I had to add a a 1/2" trim ring under the speaker to make up the difference from the stock speaker. I found the most shallow speaker I could find. It is very shallow at only 2" on the nose. The factory speaker just couldn't handle the power. Be aware that the factory 8" sub is 2 ohms per voice coil when connecting up. Lastly, connect the bluetooth from your car to your phone. Since this clock is wrong, the ETA given during route guidance is also wrong. This results in an error in the RNS-E internal clock. Subwoofer voice coils usually come in 2-ohm, 4-ohm, or 8-ohm impedances. The impedance load, or resistance against the amplifiers output signal, of a subwoofer coil. This gives you more options for wiring the sub in different situations. The problem is that the time and date signals from the cluster are not completely understood. A dual voice coil sub with four wiring terminal posts, two positive terminals and two negative terminals. It should cycle on/off while you’re holding down the button. When a navigation route is programmed, the RNS-E gives an estimated time of arrival (ETA). Wait 45 seconds, and then hold the power button for another 45 seconds. I removed the factory radio and ran power and ground and connected up. To do this, hold down the power button for 45 seconds with the car on. It also has crossovers built in, so the only passive crossovers I used were for the tweeter. I went with the JL Audio HD900/5 amp it fits directly under the seat where the factory amp is located. You can see that the all the frequency crossover is taking place in the amp so you must have an amp that has a crossover built in as well as passively you must crossover the tweeters. I am looking to see if the speakers are electronically crossed over at the amp - Here's what I found Next - I Checked to see the signals going to the speakers. I couldn't take the factory setup any longer.įirst thing I did was find out the wiring going from the Amp to the speakers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |